The first step in attaching the keel, stem , and stern post is to create these pieces individually. The stern post was relatively simple, just some minor shaping to give the slight curve at the end (not visible in these photos). The keel is just a straight piece of 1/8th inch by 1/8th inch square basswood (again very simple).The tough part is the stem, which follows the curve of bow. This piece I made using two sets of three pieces of the same 1/8th in x 1/8th in basswood all glued together and then these two pieces glued together to give enough room to draw, and then carve the correct shape. (see photo above) After carving, sanding, and shaping all of the pieces were ready to go on.
Some wood glue, some careful (stick it on there) and a few rubber bands hold it together. Now we wait.
No comments:
Post a Comment