Well, with some makeshift tools and a lot of wondering what I was doing I drew the waterline on the model.
I measured, re-measured, and then measured the other side, and after all that I think I might have done a good job.
Of course being a perfectionist means that I started all over and drew the line again, but it went right over the top of the other waterline.
Now that the line is marked I'm just going to have to accept where it is. It is now time to apply copper plates the model below the waterline. I first have to cut out each of the 1/8th in x 1/4in copper plates ( a tedious task) and then the application can begin.
No comments:
Post a Comment